Use the G Filter Options to limit the processing (solid modeling, log plotting, etc.) to data points with measured data within a specified range. This filter is not available for lithology data.
! You can use any combination of these filters. Note that the discard filter will be applied first, then the replacement filter.
- Discard Low Values: Check this box if you wish to set a lower G value limit for your data, and wish to ignore lower values altogether.
- Cutoff Value: Type in the low-value threshold. Any points with measured values lower than this threshold will not be included in the model , diagram, exported list, etc.
- Discard High Values: Check this box if you wish to set an upper G value limit for your data, and wish to ignore higher values altogether.
- Cutoff Value: Type in the high-value threshold. Any points with measured values greater than this threshold will not be included in the processing.
- Replace Low Values: Check this box if you wish to set a lower G value limit for your data, and wish to replace any lower values with a specific value.
- Cutoff Value: Type in the low-value threshold.
- Replacement Value: Type in the replacement value. Any points with G values less than the defined threshold will be assigned the replacement value for processing.
- Replace High Values: Check this box if you wish to set an upper G value limit for your data, and wish to replace any higher values with a specific value.
- Cutoff Value: Type in the high-value threshold.
- Replacement Value: Type in the replacement value. Any points with G values greater than the defined threshold will be assigned the replacement value for processing.
Back to Filtering Data
RockWare home page