Apply a Fence Panel G-Value Filter

Follow these steps to filter out low or high G-values from display in the 3D fence panel.

Right-click on the name of the panel to be modified (in the data pane of RockPlot3D), and choose Options. You may need to expand a group or two to access the vertical grid icon. If you have a difficult time determining which panel is which, remove a panel’s check-mark to see it disappear from the display.
Filter:Locate this section of the Grid Options window. You will see a Low and a High slider bar. Below the sliders, you will see the minimum and maximum node value.
- Low: Drag the Low slider from left to right to remove low values from the panel display. The current low value setting is displayed in the prompt to the right. You may also type a value into the prompt box.
- High: Drag the High slider from right to left to remove high values from the panel display. The current high value setting is displayed in the prompt to the right. You may type a value into the prompt box.
Click the Apply button at any time to view the effect of your filtering changes on the panel. You may need to drag the Options window out of the way to view the display. You do not need to close the Grid Options window to apply and see the changes.
! Using the Apply button tells the program to invoke the changes you have made. You cannot discard changes once they have been applied.
You can repeat this process for additional panels, without even closing the current Grid Options window. Just double-click on another panel name and its Options window will be docked with the others.

Tip: You can click the Info button at the very bottom of the window to see the grid model’s Z-value range.