Fill Depth Column

The Fill Depth Column command is available as a right-click option from within many of the LogPlot datasheets. It is used to populate automatically a single column of depth values at regular increments into a datasheet's Depth column, starting at the current cursor position in the sheet.

To add depth values to a datasheet, follow these steps:

1. Click on the tab of the datasheet to be edited, to make it active.
2. Click in the row in which the depth listing is to start.
3. Then, right-click in any of the datasheet's cells.
4. Select the Columns | Fill Column command from the pop-up menu.
5. Enter the requested information.
   • Starting Value: Enter at this prompt the depth to be listed in the row at which the cursor is currently located. This value may represent English or metric units.
   • Ending Value: Enter at this prompt the lower-most depth value to be listed on the data tab.
   • Depth Increments: Enter here the increments at which the depths are to be listed in the tab.
   • Decimals: Type in, or select with the up- or down-arrows, the number of decimal places to be represented in the depths. Be sure the decimal places are adequate to represent the requested increments.

Note: Any depth data already listed in the cells will be overwritten.

Back to Other LogPlot Data Tools

RockWare home page